Configuring the ECN330-switch
84 1553-KDU 137 365 Uen D 2006-06-16
6.3.8.2 Using DHCP/BOOTP
If the network provides DHCP/BOOTP services, the ECN330-switch can be
configured to be dynamically configured by these services.
Web – Click IP, General, Routing Interface. Specify the VLAN to which the
management station is attached, set the IP Address Mode to DHCP or BOOTP.
Click Apply to save the changes. Then click Restart DHCP to immediately
request a new address. Note that the ECN330-switch will also broadcast a
request for IP configuration settings on each power reset.
Figure 18 IP Interface Configuration - DHCP
Note: If the management connection is lost, use a console connection and
enter show ip interface to determine the new ECN330-switch address.
To Next Page
Loading...
