Command Line Interface
8951553-KDU 137 365 Uen D 2006-06-16
The default DA-MAC of MPLS uplink port is 00-00-00-00-00-00, and the
default tunnel label is disabled.
Example
Table 98 show mpls l2transport - Display Description
Console#show mpls l2transport
MPLS Vlan Infomation:
[Client Intf] [VC State] [Local VC Label] [Remote VC Label]
Vlan2 Up 100 200
Vlan3 Down N/A N/A
MPLS Up-link Port Information:
[Up-Link Intf] [Tunnel Label] [Vc Label] [NextHopIP] [Da-Mac]
port:25 9 9 192.168.1.19 00-E0-29-94-34-64
port:26 N/A N/A 0.0.0.0. 00-00-22-22-33-33
port:27 100 100 192.168.1.35 00-00-00-00-00-00
Console#
Field Description
MPLS VLAN Information
Client Intf A VLAN configured to operate as an L2MPLS tunnel. This
VLAN is connected to the client interface on the edge
switch of the service provider’s network.
VC State The status of the Virtual Channel can be one of the
following:
• UP – The VC can carry traffic between the two
endpoints.
• DOWN – The VC is not ready to carry traffic between
the two endpoints. When no input and output labels are
configured, the VC state is down
• ADMIN DOWN—The VC has been administratively
disabled.
Local VC
Label
This label determines the egress interface of a packet
arriving from the MPLS backbone.
To Next Page
Loading...
