Command Line Interface
9031553-KDU 137 365 Uen D 2006-06-16
7.19.4 queue min-bandwidth
This command assigns a minimum bandwidth to each of the priority queues that
is used for Weighted Fair Queueing (WFQ). Use the no form to restore the
default bandwidth for each queue.
Syntax
queue min-bandwidth <bandwidth0...bandwidth7>
no queue bandwidth
bandwidth0...bandwidth7 - The minimum bandwidth assigned to
queues 0 - 7. (Range: 1-100000 kbps for Fast Ethernet ports,
1-100000000 kbps for Gigabit Ethernet ports; Granularity: 64 kbps)
Default Setting
Queue bandwidth (kbps): 1754, 3508, 7017, 10526, 14035, 17534, 21052,
24561are assigned to queues 0 - 7 respectively
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• WFQ shares bandwidth at the egress ports by specifying a minimum
bandwidth for each queue. Guaranteed bandwidth is first supplied to
each queue, any remaining bandwidth is distributed in a round-robin
fashion.
• Use the queue mode command (section 7.19.1 on page 898) to set the
queue mode to wfq or strict-wfq before setting the minimum queue
bandwidths.
To Next Page
Loading...
