Ericsson ECN330 - Page 917

Command Line Interface
9111553-KDU 137 365 Uen D 2006-06-16
7.19.11 map ip port (Interface Configuration)
This command sets IP port priority (TCP or UDP port priority). Use the no form
to remove a specific setting.
Syntax
map ip port <port-number> cos <cos-value>
no map ip port <port-number>
• port-number - 16-bit TCP or UDP port number. (Range: 0-65535)
• cos-value - Class-of-Service value (Range: 0-7)
Default Setting
None
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• The precedence for priority mapping is IP Port, IP Precedence or IP
DSCP, and default switchport priority.
• This command sets the IP port priority for all interfaces.
Example
The following example shows how to map HTTP traffic to CoS value 0:
Console(config)#interface ethernet 1/5
Console(config-if)#map ip port 80 cos 0
Console(config-if)#