Configuring the ECN330-switch
86 1553-KDU 137 365 Uen D 2006-06-16
6.3.9 Managing Firmware
Firmware can be uploaded/downloaded to or from a TFTP server. By saving
runtime code to a file on a TFTP server, that file can later be downloaded to the
ECN330-switch to restore operation. The ECN330-switch can also be set to use
new firmware without overwriting the previous version. Specify the method of file
transfer, along with the file type and file names as required.
Command Attributes
• File Transfer Method - The firmware copy operation includes these
options:
• file to file - Copies a file within the ECN330-switch directory,
assigning it a new name.
• file to tftp - Copies a file from the ECN330-switch to a TFTP server.
• tftp to file - Copies a file from a TFTP server to the ECN330-switch.
• TFTP Server IP Address – The IP address of a TFTP server.
• File Type – Specify opcode (operational code) to copy firmware.
• File Name –
The file name should not contain slashes (\ or /),
the leading
letter of the file name should not be a period (.), and the maximum
length for file names on the TFTP server is 127 characters or 31
characters for files on the ECN330-switch. (Valid characters: A-Z, a-z,
0-9, “.”, “-”, “_”)
Note: Up to two copies of the system software (that is, the runtime firmware)
can be stored in the file directory on the ECN330-switch. The currently
designated startup version of this file cannot be deleted.
To Next Page
Loading...
