Configuring the ECN330-switch
871553-KDU 137 365 Uen D 2006-06-16
6.3.9.1 Downloading System Software from a Server
When downloading runtime code, specify the destination file name to replace
the current image, or first download the file using a different name from the
current runtime code file, and then set the new file as the startup file.
Web – Click System, File Management, Copy Operation. Select “tftp to file” as
the file transfer method, enter the IP address of the TFTP server, set the file type
to “opcode,” enter the file name of the software to download, select a file on the
ECN330-switch to overwrite or specify a new file name, then click Apply. If the
current firmware used for startup is replaced, reboot the system through the
System/Reset menu to start using the new operation code.
Figure 19 Copy Firmware
If downloading to a new destination file, go to the File Management, Set Start-
Up menu, mark the operation code file used at startup, and click Apply. To start
the new firmware, reboot the system using the System/Reset menu.
Figure 20 Setting the Startup Code
To Next Page
Loading...
