Configuring the ECN330-switch
88 1553-KDU 137 365 Uen D 2006-06-16
To delete a file select System, File Management, Delete. Select the file name
from the given list by checking the tick box and click Apply. Note that the file
currently designated as the startup code cannot be deleted.
Figure 21 Deleting Files
CLI – To download new firmware form a TFTP server, enter the IP address of
the TFTP server, select “config” as the file type, then enter the source and
destination file names. When the file has finished downloading, set the new file
to start up the system, and then restart the ECN330-switch.
To start the new firmware, enter the “reload” command or reboot the system.
Console#copy tftp file
TFTP server ip address: 10.1.0.19
Choose file type:
1. config: 2. opcode: 3. diag: 4. loader: 2
Source file name: CXC_132_8902_V3.15.BIX
Destination file name: CXC_132_8902_V3.15.BIX
\Write to FLASH Programming.
-Write to FLASH finish.
Success.
Console#config
Console(config)#boot system opcode:CXC_132_8902_V3.15.BIX
Console(config)#exit
Console#reload
To Next Page
Loading...
