Command Line Interface
9311553-KDU 137 365 Uen D 2006-06-16
Example
This example creates a policy called “rd_policy,” uses the class command to
specify the previously defined “rd_class,” uses the set command to classify the
service that incoming packets will receive, and then uses the police command
to limit the average bandwidth to 100,000 Kbps, the burst rate to 1522 bytes, and
configure the response to drop any violating packets.
7.20.7 service-policy
This command applies a policy map defined by the policy-map command to the
ingress queue of a particular interface. Use the no form to remove the policy
map from this interface.
Syntax
[no] service-policy input <policy-map-name>
• input - Apply to the input traffic.
• policy-map-name - Name of the policy map for this interface.
(Range: 1-16 characters)
Default Setting
No policy map is attached to an interface.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Console(config)#policy-map rd_policy
Console(config-pmap)#class rd_class
Console(config-pmap-c)#set ip dscp 3
Console(config-pmap-c)#police 100000 1522 exceed-action drop
Console(config-pmap-c)#
To Next Page
Loading...
