Configuring the ECN330-switch
90 1553-KDU 137 365 Uen D 2006-06-16
• File Type – Specify config (configuration) to copy configuration settings.
•
File Name
— The configuration file name should not contain slashes (\
or /),
the leading letter of the file name should not be a period (.), and
the maximum length for file names on the TFTP server is 127 characters
or 31 characters for files on the ECN330-switch. (Valid characters: A-Z,
a-z, 0-9, “.”, “-”, “_”)
Note: The maximum number of user-defined configuration files is limited
only by available flash memory space.
6.3.10.1 Downloading Configuration Settings from a Server
The configuration file can be downloaded under a new file name and then set as
the startup file, or the current startup configuration file can be specified as the
destination file to directly replace it. Note that the file
“Factory_Default_Config.cfg” can be copied to the TFTP server, but cannot be
used as the destination on the ECN330-switch.
Web – Click System, File Management, Copy Operation. Choose “tftp to startup-
config” or “tftp to file,” and enter the IP address of the TFTP server. Specify the
name of the file to download, select a file on the ECN330-switch to overwrite or
specify a new file name, and then click Apply.
Figure 22 Downloading Configuration Settings for Start-Up
To Next Page
Loading...
