FOR-A FA-9500 - Page 168

152
 Antialias
Parameter Default
Setting range
(Steps)
Description
Horizontal Normal
Weak 8-1
Normal
Strong1-8
Performs horizontal anti-aliasing for the
output video image.
Weak 8 to Strong 8 (low to high)
This setting cannot be changed if the
conversion is set to the formats indicated as
(BYPASS) in the CONV1 Conversion Table
in section 5-3-2.
Vertical Normal
Weak 8-1
Normal
Strong1-8
Performs vertical anti-aliasing for the output
video image.
Weak 8 to Strong 8 (low to high)
This setting cannot be changed if the
conversion is set to the formats indicated as
(BYPASS) in the CONV1 Conversion Table
in section 5-3-2.
The Antialias setting cannot be changed if Converter1 Process Mode is set to BY-PASS, or if
the conversion is set to the formats indicated as (BY-PASS) in the CONV1 Conversion Table
(5-3-2).
 Enhance
Parameter Default
Setting range
(Steps)
Description
Enhance Level 0 Level 0-8
Sharpens the output video image.
Level 0 to 8 (low to high)
The Enhance setting cannot be changed if Converter1 Process Mode is set to BY-PASS.
Also, it cannot be changed if the conversion is set to the formats indicated as (BY-PASS) in
the CONV1 Conversion Table (5-3-2).
 Converter1 Size
Parameter Default Setting range(Steps) Description
H Size
(Horizontal Size)
100.0％
50.0 - 150.0%
(0.1%)
Adjusts the width of the video
displayed on the monitor.
V Size
(Vertical Size)
100.0％
50.0 - 150.0%
(0.1%)
Adjusts the height of the video
displayed on the monitor.
The Converter1 Size setting cannot be changed if Converter1 Process Mode is set to
BY-PASS. Also, it cannot be changed if the conversion is set to the formats indicated as
(BY-PASS) in the CONV1 Conversion Table (5-3-2).
 Converter1 Position
Parameter Default Setting range (Steps) Description
H Position
(Horizontal Position)
0 Pixel
Variable
*1
(2 Pixel)
Adjusts the horizontal position of
the video displayed on the monitor.
V Position
(Vertical Position)
0 Line
Variable
*1
(1 Line)
Adjusts the vertical position of the
video displayed on the monitor.
The Converter1 Position setting cannot be changed if Converter1 Process Mode is set to
BY-PASS. Also, it cannot be changed if the conversion is set to the formats indicated as
(BY-PASS) in the CONV1 Conversion Table (5-3-2).
*1 The Converter1 Position setting range varies depending on Converter1 Process Mode,
and Sync Format settings in FS Mode (9-4-1 Video System).