FOR-A FA-9500 - Page 203

187
 Dolby Decoder REF Input Select
Parameter Default Setting range Description
REF Input AUX REF IN
Output Video
AUX REF In
Input Video
Selects a reference signal to be used in the
Dolby decoder. PCM signal output from the
Dolby decoder will be synchronized to the
selected reference signal.
Output Video: Uses the output video signal.
AUX REF In: Uses the input signal in the
optional Dolby reference input connector (REF
IN). If no signal is in the REF IN connector, the
PCM signal output will be in free-run mode.
Input Video: Uses the input video signal as a
reference signal.
 Dolby Down Mix Mode
Parameter Default Setting range Description
Mode Surround
Surround
Stereo
Monaural
Selects a downmix mode for the
Dolby decoder.
 Dolby Decoder Gain
Parameter Default
Setting range
(Steps)
Description
Master 0.0 dB
-20.0 - +20.0 dB
(0.1 dB)
Sets offset for all Dolby-decoded
signals.
 Dolby Decoder Gain Set
Parameter Default
Setting range
(Steps)
Description
CH 1-8
Down Mix L CH
Down Mix R CH
0.0 dB
-20.0 - +20.0 dB*1
(0.1 dB)
Sets gain for each Dolby decoder
channel.
*1 The total Master and individual channel gain setting value cannot exceed the above setting
range.