224
CONV1/2 S2016-3 Output Status
Displays the status of S2016-3 in Converter 1 and 2 output signals.
Status: Displays Present if ancillary data is inserted. Displays Absent if no ancillary data is
inserted. If ANC Mode under Converter1 Ancillary Setting in the Video System menu (Sec.
9-4-1) is set to H/V ANC, the state of the V ANC setting (Pass or Blank) will be displayed.
AFD: Displays Active Format Description code in binary format.
AR: Displays the aspect ratio as 4:3 or 16:9 and the inserted AFD type.
Data: Displays the detected 8-byte data in hexadecimal format.
CONV1/2 VI Output Status
Displays the status of RP186 VI in Converters 1 and 2 output signals.
Status: Displays Present if ancillary data is inserted. Displays Absent if no ancillary data is
inserted. If ANC Mode under Converter1 Ancillary Setting in the Video System menu (Sec.
9-4-1) is set to H/V ANC, the state of the V ANC setting (Pass or Blank) will be displayed.
AFD: Displays Active Format Description code in bynary format.
Scan: Displays the Scanning System and the inserted AFD type.
Data1-3: Displays the detected data in hexadecimal format.
CONV1/2 WSS Output Status
Displays the status of BT1119-2 WSS in Converters 1 and 2 output signals.
Status: Displays Present if ancillary data is inserted. Displays Absent if no ancillary data is
inserted. If ANC Mode under Converter1 Ancillary Setting in the Video System menu (Sec.
9-4-1) is set to H/V ANC, the state of the V ANC setting (Pass or Blank) will be displayed.
AFD: Displays Active Format Description code in hexadecimal format and the AFD type.
Bit 13-0: Displays the inserted Bit13 to Bit0 in hexadecimal format.
CONV1/2 Ancillary Data Packet Output Status
Displays the content, names and inserted lines of the 4 total ancillary data packets inserted
into Converter 1 and 2 output signals.
See section 19. “FA-9500 Ancillary Data Packet Name List” for details on ancillary data
names, and DID and SDID of formats.
Displays “----“ if no ancillary data is inserted.
To Next Page
Loading...
