GE HEALTHCARE
DIRECTION 2307224-100, REVISION 6DISCOVERY LS SYSTEM SERVICE MANUAL
Page 190 Chapter 6 - Table
6.2.7.2 Table Cover and Bracket Task List
Note: All the drawings in this section are shown without the upper table assembly.
Refer to Figure 6-112. Assemble the lower table covers and brackets in the following order:
1.) Install the roller cover assembly:
a.) Attach the roller cover guides to the secondary base side rails.
b.) Attach the cover bracket to the secondary base and align to roller cover guides.
c.) If necessary, move the ground bus bar to accommodate the roller canister.
d.) Attach canister brackets to the head end of the secondary base.
e.) Attach the drip trough to the roller canister assembly.
f.) Attach the canister to the secondary base.
g.) Install the idler roller and align it to the roller cover guides.
2.) Fasten the side skirts to the secondary base:
a.) Attach left and right side covers to the secondary base.
b.) Attach front left and right side covers to the secondary base.
3.) Fasten the rear covers to the secondary base.
a.) Attach the Back Cap Bracket to the foot end of the secondary base.
b.) Attach the Table Top Cover to the table brackets.
c.) Attach the Top Cap Short Cover to the secondary base.
d.) Attach the Back Cap to the foot end of the secondary base.
Figure 6-112: Secondary Base Covers
Front Covers
Rear Covers
To Next Page
Loading...
