5. Align the bracket with the two mounting holes located toward the top center of the
chassis.
There is no mounting hole in the center of the chassis that corresponds to the hole in
the center of the bracket.
6. Insert the two screws at the top of the bracket and tighten each partially.
Two screws are needed for mounting the bracket on the center of the chassis. You
do not need the third screw.
7. Tighten the two screws completely.
8. Repeat the procedure for the other bracket.
Related
Documentation
• Installing the MX480 Router Using a Mechanical Lift on page 194
• Tools Required to Install the MX480 Router Without a Mechanical Lift on page 201
Copyright © 2017, Juniper Networks, Inc.186
MX480 3D Universal Edge Router Hardware Guide
To Next Page
Loading...
