PIC 2 Online 10x 1GE(LAN)
PIC 3 Online 10x 1GE(LAN)
Slot 2 Online DPCE 40x 1GE R
PIC 0 Online 10x 1GE(LAN)
PIC 1 Online 10x 1GE(LAN)
PIC 2 Online 10x 1GE(LAN)
PIC 3 Online 10x 1GE(LAN)
Slot 5 Online DPC 4x 10GE R
PIC 0 Online 1x 10GE(LAN/WAN)
PIC 1 Online 1x 10GE(LAN/WAN)
PIC 2 Online 1x 10GE(LAN/WAN)
PIC 3 Online 1x 10GE(LAN/WAN)
For further description of the output from the command, see the CLI Explorer.
Related
Documentation
MX480 Chassis Description on page 9•
• DPC and MPC LEDs on the MX480 Craft Interface on page 17
Holding an MX480 DPC
When carrying a DPC, you can hold it either vertically or horizontally.
NOTE: A DPC weighs 14.5 lb (6.6 kg). Be prepared to accept the full weight
of the DPC as you lift it.
To hold a DPC vertically:
1. Orient the DPC so that the faceplate faces you. To verify orientation, confirm that the
text on the DPC is right-side up and the electromagnetic interference (EMI) strip is on
the right-hand side.
2. Place one hand around the DPC faceplate about a quarter of the way down from the
top edge. To avoid deforming the EMI shielding strip, do not press hard on it.
3. Place your other hand at the bottom edge of the DPC.
If the DPC is horizontal before you grasp it, place your left hand around the faceplate and
your right hand along the bottom edge.
To hold a DPC horizontally:
1. Orient the DPC so that the faceplate faces you.
2. Grasp the top edge with your left hand and the bottom edge with your right hand.
You can rest the faceplate of the DPC against your body as you carry it.
Copyright © 2017, Juniper Networks, Inc.422
MX480 3D Universal Edge Router Hardware Guide
To Next Page
Loading...
