CHAPTER 21
Installing Components
•
Installing the MX480 Craft Interface on page 251
•
Installing the MX480 Air Filter on page 252
•
Installing the MX480 Fan Tray on page 253
•
Installing an MX480 Routing Engine on page 254
•
Installing an MX480 DPC on page 256
•
Installing a Cable on an MX480 DPC, MPC, MIC, or PIC on page 259
•
Installing an MX480 FPC on page 261
•
Installing an MX480 MIC on page 264
•
Installing an MX480 Dual-Wide MIC on page 266
•
Installing an MX480 MPC on page 269
•
Installing an MX480 PIC on page 271
•
Installing an MX480 AS MLC on page 274
•
Installing an MX480 AS MSC on page 275
•
Installing an MX480 AS MXC on page 277
•
Installing an MX480 AC Power Supply on page 278
•
Installing an MX480 DC Power Supply on page 280
•
Installing an MX480 SCB on page 283
•
Installing an SFP or XFP Transceiver into an MX480 DPC, MPC, MIC, or PIC on page 285
Installing the MX480 Craft Interface
To install the craft interface (see Figure 91 on page 252):
1. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
ESD points on the chassis.
2. Grasp the craft interface with one hand, and hold the bottom edge of the craft interface
with the other hand to support its weight.
3. Orient the ribbon cable so that it plugs into the connector socket. The connector is
keyed and can be inserted only one way.
251Copyright © 2017, Juniper Networks, Inc.
To Next Page
Loading...
