Figure 160: Installing an AC Power Supply in an MX480 Router
See Also Preventing Electrostatic Discharge Damage to an MX480 Router on page 484•
• Removing an MX480 AC Power Supply on page 367
• MX480 AC Power Supply Description on page 100
Related
Documentation
Preventing Electrostatic Discharge Damage to an MX480 Router on page 484•
• MX480 AC Power Supply Description on page 100
Replacing an MX480 DC Power Supply
1.
Removing an MX480 DC Power Supply on page 370
2.
Installing an MX480 DC Power Supply on page 372
Removing an MX480 DC Power Supply
Before you remove a power supply, be aware of the following:
NOTE: The minimum number of powersuppliesmust be presentin the router
at all times.
WARNING: Before performing DC power procedures, ensure that power is
removed from the DC circuit. To ensure that all power is off, locate the circuit
breaker on the panel board that services the DC circuit, switch the circuit
Copyright © 2017, Juniper Networks, Inc.370
MX480 3D Universal Edge Router Hardware Guide
To Next Page
Loading...
