Juniper MX480 - Connecting the MX480 Router to the Network; Tools and Parts Required for MX480 Router Connections; Connecting the MX480 Router to Management and Alarm Devices

CHAPTER 18
Connecting the MX480 Router to the
Network
•
Tools and Parts Required for MX480 Router Connections on page 231
•
Connecting the MX480 Router to Management and Alarm Devices on page 231
•
Connecting the MX480 Router to a Network for Out-of-Band Management on page 234
•
Connecting the MX480 Router to a ManagementConsole or Auxiliary Deviceon page 235
•
Connecting the MX480 Router to an External Alarm-Reporting Device on page 236
•
Connecting DPC, MPC, MIC, or PIC Cables to the MX480 Router on page 237
•
Connecting the Alarm Relay Wires to the MX480 Craft Interface on page 239
Tools and Parts Required for MX480 Router Connections
To connect the router to management devices and line cards, you need the following
tools and parts:
•
Phillips (+) screwdrivers, numbers 1 and 2
•
2.5-mm flat-blade (–) screwdriver
•
2.5-mm Phillips (+) screwdriver
•
Wire cutters
•
Electrostatic discharge (ESD) grounding wrist strap
Related
Documentation
Connecting the MX480 Router to Management and Alarm Devices on page 231•
Connecting the MX480 Router to Management and Alarm Devices
•
Connecting the MX480 Router to a Network for Out-of-Band Management on page 232
•
Connecting the MX480 Router to a ManagementConsole or Auxiliary Device on page 232
•
Connecting the MX480 Router to an External Alarm-Reporting Device on page 233
231Copyright © 2017, Juniper Networks, Inc.