user@host>request chassis pic fpc-slot fpc-slot pic-slot pic-slot online
For more information about the command, see the CLI Explorer.
•
To bring a MIC online:
•
Press the MIC offline/online button until the MIC LED lights green.
•
Issue the following CLI command:
user@host>request chassis mic fpc-slot mpc-slot pic-slot mic-slot online
For more information about the command, see the CLI Explorer.
The normal functioning indicator LED confirms that the component is online. You can
also verify correct DPC or MPC functioning by issuing the show chassis fpc command
or correct MIC or the PIC functioning by issuing the show chassis fpc pic-status
command.
Related
Documentation
Preventing Electrostatic Discharge Damage to an MX480 Router on page 484•
• Removing a Cable on an MX480 DPC, MPC, MIC, or PIC on page 329
• Maintaining Cables That Connect to MX480 DPCs, MPCs, MICs, or PICs on page 434
Installing an MX480 FPC
An FPC takes up two DPC slots on the MX480 router. Up to three FPCs can be installed
horizontally in the front of the router. The FPCs are hot-insertable and hot-removable.
An empty FPC3 weighs 14 lb (6.5 kg). A fully configured FPC can weigh up to 18 lb (8.2 kg).
Be prepared to accept its full weight.
To install an FPC (see Figure 97 on page 263):
1. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
ESD points on the chassis.
2. Place the FPC on an antistatic mat.
3. Take each PIC to be installed in the replacement FPC out of its electrostatic bag, and
identify the slot on the FPC where it will be connected.
4. Verify that each fiber-optic PIC has a rubber safety cap covering the PIC transceiver.
If it does not, cover the transceiver with a safety cap.
5. Install each PIC into the appropriate slot on the FPC.
6. Locate the slots in the card cage in which you plan to install the FPC.
261Copyright © 2017, Juniper Networks, Inc.
Chapter 21: Installing Components
To Next Page
Loading...
