EasyManua.ls Logo

Juniper MX480 - Warning Statement for Norway and Sweden; Preventing Electrostatic Discharge Damage to an MX480 Router

Juniper MX480
552 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
We recommend that you dispose of any irreparably damaged equipment in an
environmentally responsible manner.
Related
Documentation
General Safety Guidelines and Warnings on page 479
General Electrical Safety Guidelines and Warnings on page 505
Action to Take After an Electrical Accident on page 517
Warning Statement for Norway and Sweden
WARNING: The equipment must be connected to an earthed mains
socket-outlet.
Advarsel Apparatet skal kobles til en jordet stikkontakt.
Varning! Apparaten skall anslutas till jordat nätuttag.
Related
Documentation
General Safety Guidelines and Warnings on page 479
Preventing Electrostatic Discharge Damage to an MX480 Router
Many router hardware components are sensitive to damage from static electricity. Some
components can be impaired by voltages as low as 30 V. You can easily generate
potentially damaging static voltages whenever you handle plastic or foam packing
material or if you move components across plastic or carpets. Observe the following
guidelines to minimize the potential for electrostatic discharge (ESD) damage, which
can cause intermittent or complete component failures:
Always use an ESD wrist strap or ankle strap, and make sure that it is in direct contact
with your skin.
CAUTION: For safety, periodically check the resistance value of the ESD
strap. The measurement should be in the range of 1 through 10 Mohms.
When handling any component that is removed from the chassis, make sure the
equipment end of your ESD strap is attached to one of the ESD points on the chassis.
Avoid contact between the component and your clothing. ESD voltages emitted from
clothing can still damage components.
When removing or installing a component, always place it component-side up on an
antistatic surface, in an antistatic card rack, or in an electrostatic bag (see
Figure 190 on page 485) . If you are returning a component, place it in an electrostatic
bag before packing it.
Copyright © 2017, Juniper Networks, Inc.484
MX480 3D Universal Edge Router Hardware Guide

Table of Contents

Other manuals for Juniper MX480

Related product manuals