Bottom Tray Fan 1 OK Spinning at high speed
Bottom Tray Fan 2 OK Spinning at high speed
Bottom Tray Fan 3 OK Spinning at high speed
Bottom Tray Fan 4 OK Spinning at high speed
Bottom Tray Fan 5 OK Spinning at high speed
Bottom Tray Fan 6 OK Spinning at high speed
Related
Documentation
Routine Maintenance Procedures for the MX480 Router on page 413•
• Installing the MX480 Fan Tray on page 253
Maintaining the MX480 Host Subsystem
Purpose For optimum router performance, verify the condition of the host subsystem. The host
subsystem comprises an SCB and a Routing Engine installed directly into an SCB.
Action On a regular basis:
• Check the LEDs on the craft interface to view information about the status of the
Routing Engines.
• Check the LEDs on the SCB faceplate.
• Check the LEDs on the Routing Engine faceplate.
• To check the status of the Routing Engines, issue the show chassis routing-engine
command. The output is similar to the following:
user@host> show chassis routing-engine
Routing Engine status:
Slot 0:
Current state Master
Election priority Master (default)
Temperature 45 degrees C / 113 degrees F
CPU temperature 43 degrees C / 109 degrees F
DRAM 2048 MB
Memory utilization 15 percent
CPU utilization:
User 0 percent
Background 0 percent
Kernel 8 percent
Interrupt 0 percent
Idle 92 percent
Model RE-S-1300
Serial ID 1000694968
Start time 2007-07-10 12:27:39 PDT
Uptime 1 hour, 40 minutes, 37 seconds
Load averages: 1 minute 5 minute 15 minute
0.11 0.06 0.01
Routing Engine status:
Slot 1:
Current state Backup
Election priority Backup (default)
Temperature 46 degrees C / 114 degrees F
CPU temperature 42 degrees C / 107 degrees F
DRAM 2048 MB
Copyright © 2017, Juniper Networks, Inc.418
MX480 3D Universal Edge Router Hardware Guide
To Next Page
Loading...
Need help?
General
