Diagnostic Information 2-9
4023-001
Menus Disabled The printer menus have
been disabled. This
occurs when <Menu> is
pressed while the printer
is Ready and Menu
Lockout is active.
The printer display
shows this message for
one second and then
returns to the Ready
message.
No button actions are
possible while this mes-
sage is displayed.
If the operator has disabled
the menu and you want to
run operator print tests,
turn the machine off and
then press Go and Stop as
you turn the machine on.
Not Ready The printer is in the Not
Ready state, which
means it is not ready to
receive or process data.
This message displays
when Stop is pressed
during a print job.
Press Go to take the
printer out of the not ready
state.
Or, to reset the printer:
•Press <Menu> to
access the Busy menu.
•Select Reset Printer.
Performing Self
Test
The printer is running
the normal series of
start-up tests after it is
powered on. When the
tests are complete, the
printer returns to Ready.
No button actions are
possible while this mes-
sage is displayed.
Printer performs self-test.
Remove Paper
Standard Bin
Remove paper. Check paper exit full
sensor (PC12) and
connectors. Replace
printer main engine board
(PWB-A) if necessary.
Remove Paper
Output Bin X
Remove paper. Check exit full sensor for
designated device and bin.
Message Description Action
To Next Page
Loading...
