Lexmark Optra W810 - Page 121

Diagnostic Information 2-13
4023-001
34 Wrong Paper
Size in Tray x
Install correct paper
size.
Check paper size detection
board.
• Tray 1–PWB-S1
• Tray 2,3–PWB-S2
Replace if necessary.
Replace printer main
engine board (PWB-A) if
necessary.
35 Res Save Off
Deficient Memory
The printer lacks the
memory needed to
enable Resource Save.
This message usually
indicates that too much
memory is allocated for
one or more of the
printer link buffers.
• To enable Resource
Save after this message
is displayed, either
install additional memory
or set each link buffer to
the Auto value.
• After you set all link buff-
ers to Auto, exit the
printer menus to activate
link buffer changes.
• When Ready is dis-
played, enable
Resource Save in the
Setup Menu and modify
the link buffers again.
•Press Go to clear the
message. The printer
automatically disables
Resource Save and
continues.
37 Insufficient
Collation Area
This message is
displayed when the
printer memory used to
store pages is too full to
collate the print job.
•Press
Go to print the
portion of the job already
stored and begin collat-
ing the rest of the job.
• Cancel the print job.
Press
Menu> or <Menu.
The Job Menu is dis-
played. Press
Menu> or
<Menu until Cancel Job
appears on the second
line. Press
Select.
37 Insufficient
Defrag Memory
See operator manual.
Message Description Action