MacDon D1 Series - Page 10

Section
Summary of Change
Internal Use
Only
• Step 3, page 209
• If you do not disconnect the battery before connecting the
cab draper control harness to the combine’s auxiliary power
connectors, electrical components may be damaged.
7.1.1 Attaching Header to an
AGCO (Challenger, Gleaner, or
Massey Ferguson) Combine, page
205
• Table 7.2, page 207
Added “AGCO” to the kit number column.
Tech Pubs
7.2 AGCO IDEAL
™
Series
Combines, page 213
7.2.1 Attaching Header to an
AGCO IDEAL
™
Series Combine,
page 213
7.2.2 Installing Reel Fore-Aft /
Header Tilt Selector Switch, page
216
Added AGCO IDEAL
™
topics
ECN 57194
7.3.1 Attaching Header to Case
IH Combine, page 218
• Step 1, page 218
Added safety step:
• Shut down the engine, and remove the key from the ignition.
Tech Pubs
7.4.1 Attaching Header to CLAAS
Combine, page 224
• Step 1, page 224
Added safety step:
• Shut down the engine, and remove the key from the ignition.
Tech Pubs
7.5.1 Attaching Header to John
Deere Combine, page 229
• Step 1, page 229
Added safety step:
• Shut down the engine, and remove the key from the ignition.
Tech Pubs
7.5.2 Installing Reel Fore-Aft /
Header Tilt Switch – S and
T Series Combines, page 232
Replaced the DANGER with the following WARNING to be
consistent with similar procedures:
• To avoid injury or death from unexpected start-up of
machine, always stop the engine and remove the key from
the ignition before leaving the operator’s seat for any reason.
Tech Pubs
7.5.2 Installing Reel Fore-Aft /
Header Tilt Switch – S and
T Series Combines, page 232
• Step 1, page 232
Revised step to mean tilting the feeder house, not the header, all
the way forward.
Product Support
7.5.3 Installing Reel Fore-Aft /
Header Tilt Switch – 60 and 70
Series Combines, page 239
Replaced the DANGER with the following WARNING to be
consistent with similar procedures:
• To avoid injury or death from unexpected start-up of
machine, always stop the engine and remove the key from
the ignition before leaving the operator’s seat for any reason.
Tech Pubs
7.5.3 Installing Reel Fore-Aft /
Header Tilt Switch – 60 and 70
Series Combines, page 239
• Step 1, page 239
Added safety steps and revised IMPORTANT to be consistent with
similar procedures.
• Procedure now says to disconnect the battery negative cable,
not the positive cable.
Tech Pubs
215184 viii Revision A