MacDon D1 Series - Page 11

Section
Summary of Change
Internal Use
Only
• Step 2, page 239
• Step 3, page 239
7.6.1 Attaching Header to New
Holland CR/CX Combine, page
244
• Step 1, page 244
Added safety step:
• Shut down the engine, and remove the key from the ignition.
Tech Pubs
7.7.1 Positioning Transport
Lights, page 249
• Step 1, page 249
• Step 2, page 249
Updated picture to show additional nut used to mount transport
light assembly.
ECN 58057
7.7.1 Positioning Transport
Lights, page 249
• Step 3, page 249
• Updated picture to show an additional nut used to mount
transport light assembly.
• Revised picture to show the accurate shipping position of the
transport light assembly.
ECN 58057
Engineering
7.7.1 Positioning Transport
Lights, page 249
• Step 4, page 250
Updated picture to show an additional nut used to mount
transport light assembly.
ECN 58057
8 Performing Predelivery Checks,
page 257
• Step 1, page 257
Added safety step:
• Shut down the engine, and remove the key from the ignition.
Tech Pubs
8.2 Checking Wheel Bolt
Torque – Transport and Stabilizer
Wheels, page 258
Added “Transport and Stabilizer Wheels” to the topic title.
Tech Pubs
8.3 Checking Knife Drive Box,
page 259
Added safety step:
• Shut down the engine, and remove the key from the ignition.
Tech Pubs
8.6.1 Checking and Tensioning
Single and Untimed Double-Knife
Drive Belts, page 263
Added safety step:
• Shut down the engine, and remove the key from the ignition.
Tech Pubs
8.8 Centering the Reel, page 268
• Figure 8.17, page 269
Added NOTE and associated picture for clarity.
Product Support
8.10 Checking and Adjusting Skid
Shoe Settings, page 276
Changed the following WARNING to a DANGER:
• To avoid bodily injury or death from unexpected start-up or
fall of raised machine, always stop engine, remove key, and
engage safety props before going under machine for any
reason.
Removed the following redundant DANGER:
• Engage header safety props and reel props before working
under header or reel.
Tech Pubs
215184 ix Revision A