MacDon D1 Series - Page 9

Section
Summary of Change
Internal Use
Only
• To avoid bodily injury or death from unexpected start-up or
fall of a raised machine, always stop engine and remove key
before leaving the operator’s seat, and always engage safety
props before going under the machine for any reason.
6.2.10 Installing Feed Auger
Fingers, page 198
• Step 3, page 199
• Step 6, page 200
Changed torque from 8.5 Nm (75 lbf∙in) to 9 Nm (80 lbf∙ in).
Engineering
6.2.11 Removing Feed Auger
Fingers, page 200
Removed the following DANGER only because this procedure is
for the initial setup of the float module (the float module is not
operational at this point):
• To avoid bodily injury or death from unexpected start-up or
fall of a raised machine, always stop engine and remove key
before leaving the operator’s seat, and always engage safety
props before going under the machine for any reason.
Tech Pubs
6.2.11 Removing Feed Auger
Fingers, page 200
• Step 4, page 201
• Step 5, page 201
Changed torque from 8.5 Nm (75 lbf∙in) to 9 Nm (80 lbf∙ in).
Engineering
6.3.2 CR Feeder Deflectors, page
202
Added introductory statement:
• This section is for New Holland CR combines only. If operating
a New Holland CX combine, remove feed deflectors.
Tech Pubs
6.3.3 Replacing CR Feeder
Deflectors, page 203
Changed the following WARNING to DANGER for consistency:
• To avoid bodily injury or death from unexpected start-up or
fall of a raised machine, always stop engine and remove key
before leaving the operator’s seat, and always engage safety
props before going under the machine for any reason.
Tech Pubs
7 Attaching Header to Combine,
page 205
• Table 7.1, page 205
Added AGCO IDEAL
™
.
ECN 57194
7.1.1 Attaching Header to an
AGCO (Challenger, Gleaner, or
Massey Ferguson) Combine, page
205
• Step 1, page 205
Added safety step:
• Shut down the engine, and remove the key from the ignition.
Tech Pubs
7.1.2 Installing Reel Fore-Aft /
Header Tilt Selector Switch and
Harness, page 209
• Step 1, page 209
Revised step to mean tilting the feeder house, not the header, all
the way forward.
Product Support
7.1.2 Installing Reel Fore-Aft /
Header Tilt Selector Switch and
Harness, page 209
Revised the IMPORTANT as follows for consistency with similar
procedures:
Tech Pubs
215184 vii Revision A