MacDon D1 Series - Page 8

Section
Summary of Change
Internal Use
Only
6.2.3 Converting from Medium
Configuration or Wide
Configuration to Narrow
Configuration, page 185
Reworded introductory NOTE as follows:
• Flighting performs best when no gaps are present. If desired,
use silicone sealant to fill the gaps.
Product Support
6.2.3 Converting from Medium
Configuration or Wide
Configuration to Narrow
Configuration, page 185
• Step 10, page 186
Added NOTE. Tech Pubs
6.2.6 Converting from Ultra
Narrow or Narrow Configuration
to Wide or Ultra Wide
Configuration, page 190
Removed footnote:
• MD #287031 contains wear-resistant flightings, and is
available only through MacDon Parts.
Tech Pubs
6.2.6 Converting from Ultra
Narrow or Narrow Configuration
to Wide or Ultra Wide
Configuration, page 190
• Step 6, page 191
• Step 8, page 191
Removed NOTE:
• Flightings are NOT included in this kit. Order flighting kit
MD #287031 separately.
Tech Pubs
6.2.7 Converting from Wide
Configuration to Ultra Wide
Configuration, page 192
Changed topic title. Was previously titled “Optional Modification
to Wide Configuration."
Tech Pubs
6.2.8 Converting from Medium
Configuration or Wide
Configuration to Ultra Narrow
Configuration, page 192
• Step 30, page 195
Simplified NOTE:
• Flighting performs best when no gaps are present. If desired,
use silicone sealant to fill the gaps.
Product Support
6.2.8 Converting from Medium
Configuration or Wide
Configuration to Ultra Narrow
Configuration, page 192
• Step 32, page 195
Changed torque from 8.5 Nm (75 lbf∙in) to 9 Nm (80 lbf∙ in).
Engineering
6.2.9 Converting from Narrow
Configuration to Ultra Narrow
Configuration, page 196
• Step 18, page 198
Simplified NOTE:
• Flighting performs best when no gaps are present. If desired,
use silicone sealant to fill the gaps.
Product Support
6.2.9 Converting from Narrow
Configuration to Ultra Narrow
Configuration, page 196
• Step 20, page 198
Changed torque from 8.5 Nm (75 lbf∙in) to 9 Nm (80 lbf∙ in).
Engineering
6.2.10 Installing Feed Auger
Fingers, page 198
Removed the following DANGER only because this procedure is
for the initial setup of the float module (the float module is not
operational at this point):
Tech Pubs
215184 vi Revision A