12.7 H: TERMINALS
602 SIEPCYEUOQ2V01A Q2V Technical Manual
Figure 12.87 Example of Frequency Detection 4 (value of L4-03 Is Positive)
■ 17: @Fast Stop
Setting Value Function Description
17 @Fast Stop
The terminal activates when the fast stop is in operation.
■ 18: @KEBridethru
Setting Value Function Description
18 @KEBridethru
The activates during KEB Ride-Thru.
Note:
Refer to “KEB Ride-Thru Function on page 637” for more information.
■ 19: @ShortCBraking
Setting Value Function Description
19 @ShortCBraking
The terminal activates during Short Circuit Braking.
Note:
• When A1-02 = 8 [Control Method = EZ Vector], this function is available when you use a PM motor.
• Refer to "b2: DC INJ / SHORT CKT BRAKE on page 454" for more information.
■ 1A: @BaseblockNO
Setting Value Function Description
1A @BaseblockNO
The terminal turns on during baseblock. When the drive is in baseblock, the drive output transistor stops switching and does not
make DC bus voltage.
ON : During baseblock
OFF : The drive is not in baseblock.
■ 1B: @BaseblockNC
Setting Value Function Description
1B @BaseblockNC
The terminal deactivates during baseblock. When the drive is in baseblock, the drive output transistor stops switching and does
not make DC bus voltage.
ON : The drive is not in baseblock.
OFF : During baseblock
■ 1C: FreqRefSource
Setting Value Function Description
1C FreqRefSource
Shows the selected frequency reference source.
ON : The keypad is the frequency reference source.
OFF : Parameter b1-01 or b1-15 [Freq. Ref. Sel. 1 or Freq. Ref. Sel. 2] is the frequency reference
source.
To Next Page
Loading...
Need help?
General