Configuring SRP Targets (CLI)
initiators in the group or groups to which it belongs. If a LUN is not explicitly associated with
an initiator group, it is in the default initiator group and can be accessed by all initiators. While
using the default initiator group can be useful for evaluation purposes, its use is discouraged
since it may result in exposure of the LUN to unwanted or conflicting initiators.
To avoid possible LUN conflicts when an initiator belongs to multiple groups, configure
initiators within all groups before associating groups with LUNs.
To configure targets, go to the Configuration > SAN BUI page, use Fibre Channel, iSCSI, and
SRP to navigate, and then configure the Ports, Initiator, and Target Groups controls.
To associate a LUN, go to the Shares > Shares > Protocols page and then configure the Target
Group and Initiator Group controls.
FIGURE 12
Associate a LUN
Configuring the Appliance 149
To Next Page
Loading...
