Configuring LDAP Security Settings (CLI)
■
Anonymous - Gives the appliance access only to data that is available to everyone. To
optionally enable the SSL and TLS protocols, select the check box for Enable SSL/TLS.
■
Self - Authenticates the appliance using the user's identity and credentials. Self
authentication uses Kerberos encryption and the SASL/GSSAPI authentication method.
■
Proxy - Specifies authentication through a proxy for a specific user account. Set the
following options:
■
(Optional) Enable SSL/TLS - Select this check box to enable the SSL and TLS
protocols, which is highly recommended when using the simple authentication method
so the user's distinguished name and password are not sent as plain text.
■
Authentication Method - Select either Simple (RFC 4513) or SASL/DIGEST-MD5.
■
Proxy DN - Distinguished name of account used for proxy authentication.
■
Proxy Password - Password for account used for proxy authentication.
4.
Click APPLY.
Related Topics
■
“LDAP Properties” on page 290
Configuring LDAP Security Settings (CLI)
To configure security settings for the LDAP service, use the following procedure. For valid
property setting combinations, see the table at the end of this task.
1.
Go to configuration services ldap and enter show to view the properties.
hostname:configuration services ldap> show
Properties:
<status> = enabled
default_servers =
proxy_dn =
proxy_password =
base_dn =
search_scope = one
cred_level = anonymous
auth_method = none
use_tls = false
user_search =
user_mapattr =
user_mapobjclass =
group_search =
group_mapattr =
group_mapobjclass =
288 Oracle ZFS Storage Appliance Administration Guide, Release OS8.6.x • September 2016
To Next Page
Loading...
Need help?
General
