Cloning a Replication Package (CLI)
hostname:shares replication source-000 package-004> clone
hostname:shares replication source-000 package-004 clone>
4.
Set target_project to the project name.
The project name must be unique, or the clone operation will fail.
A project name must consist of 1 to 64 characters, but not include spaces or begin with a period.
Allowable characters are: alphanumeric and special characters _ - . :
hostname:shares replication source-000 package-004 clone> set target_project=clone
target_project = clone
5.
Enter conflicts to check for conflicts.
If conflicts exist, a message similar to the following appears.
hostname:shares replication source-000 package-004 clone> conflicts
Cloning cannot proceed because the following shares have mountpoints or
SMB resource names that are invalid or conflict with those of other shares (either on
the
system or also being failed over). Please specify valid mountpoints or SMB resource
names for
these shares:
SHARE MOUNTPOINT SHARESMB
appliances /export/appliances appliances
clothes /export/clothes (inherited) clothes (inherited)
electronics /export/electronics electronics
furniture /export/furniture (inherited) furniture (inherited)
groceries /export/groceries (inherited) groceries (inherited)
health /export/health (inherited) health (inherited)
toys /export/toys toys
hostname:shares replication source-000 package-004 clone>
Note - The conflict command can be used at any point in this procedure to check for
mountpoint or naming conflicts.
6.
(Optional) Set project-level properties to resolve conflicts for shares that inherit
properties from a project.
Use the get command to view the properties of the clone.
hostname:shares replication source-000 package-004 clone> get
target_project = clone
rename_suffix =
510 Oracle ZFS Storage Appliance Administration Guide, Release OS8.6.x • September 2016
To Next Page
Loading...
Need help?
General
