Locking Cluster Management Interfaces (CLI)
1.
Navigate to configuration services routing on the source appliance.
Use a static /32 (host-specific) route to the target system IP address via the dedicated network
interface. In the following example, mask=32 means this is a host-specific route.
host_source:configuration services routing> create
host_source:configuration services route (uncommitted)> get
family = (unset)
destination = (unset)
mask = (unset)
gateway = (unset)
interface = (unset)
host_source:configuration services route (uncommitted)> set family=IPv4
host_source:configuration services route (uncommitted)> set destination=203.34.56.78
host_source:configuration services route (uncommitted)> set mask=32
host_source:configuration services route (uncommitted)> set gateway=203.34.56.254
host_source:configuration services route (uncommitted)> set interface=nge3
host_source:configuration services route (uncommitted)> commit
host_source:configuration services routing> show
route-000 0.0.0.0/0 203.24.30.254 nge0 static
route-001 203.24.30.0/32 203.24.30.28 nge0 dynamic
route-002 203.24.150.0/32 203.24.150.10 ibd0 dynamic
route-003 203.24.101.65/32 203.24.30.254 nge1 inactive
route-005 203.34.56.78/32 203.34.56.254 nge3 static
2.
After defining the static route from the source appliance to the target appliance,
repeat these steps on the target appliance to define the static route from the
target back to the source.
3.
To ensure traffic is routed through the correct source and target interfaces, use
the traceroute command.
For information about using traceroute, see “Configuring Network Routing” on page 85.
Note - When an interface is deleted, all routes associated with the interface are also removed.
Related Topics
■
“Remote Replication Workflow” on page 470
■
“Remote Replication Concepts” on page 526
Locking Cluster Management Interfaces (CLI)
After initial configuration, clustered controllers are in an active-active state. When a failover
occurs, an active controller takes over all non-private interfaces, and the peer controller
Configuring the Appliance 75
To Next Page
Loading...
Need help?
General
