80
DOB 1300-1556 | X3-45 Commuter PA-1648 Maintenance Manual First release Oct 2020
REMOVE PULLING EQUIPMENT
Q
Remove protective film from double-face self-
adhesive tape.
R
Compress top and bottom section of side panel
S
Cut excess of side panel. Make sure that cut is
parallel with tubing.
T
Grind side panel end to line up with door tubing.
To seal each panel end, apply masking tape on each side
of side panel joint. Use a caulking nozzle and gra
221 adh
esive to fill the cavity between the panel and
vehicle structure.
Clean using Sika 205. Allow 5 minutes minimum for drying.
Wear surgical gloves and smooth down the joint with your
finger.