R&S SMA100B - Page 206

List and sweep mode
R&S
®
SMA100B
206User Manual 1178.3834.02 ─ 09
Settings
Mode........................................................................................................................... 206
ASCII File Settings......................................................................................................206
Select (ASCII) Source/Select (ASCII) Destination...................................................... 206
Select Source/Select ASCII Destination..................................................................... 207
Import / Export.............................................................................................................207
Mode
Selects import or export of a data list file. The provided parameters vary according to
the selected mode.
Remote command:
[:SOURce<hw>]:LIST:DEXChange:MODE on page 677
[:SOURce<hw>]:CORRection:DEXChange:MODE on page 642
[:SOURce<hw>]:PULM:TRAin:DEXChange:MODE on page 590
ASCII File Settings
Defines the format and the separators of the associated data file.
"Extension"
Selects *.csv or *.txt format.
"Decimal
Point"
Sets "Point" (dot) or "Comma" as the decimal separator used in the
ASCII data with floating-point numerals.
"Column Separator"
Sets the separator between the columns in an ASCII table.
Available are: "Tab", "Semicolon", "Comma" or "Space".
Remote command:
[:SOURce<hw>]:LIST:DEXChange:AFILe:EXTension on page 676
[:SOURce<hw>]:LIST:DEXChange:AFILe:SEParator:DECimal on page 676
[:SOURce<hw>]:LIST:DEXChange:AFILe:SEParator:COLumn on page 676
[:SOURce<hw>]:CORRection:DEXChange:AFILe:EXTension on page 640
[:SOURce<hw>]:CORRection:DEXChange:AFILe:SEParator:DECimal
on page 641
[:SOURce<hw>]:CORRection:DEXChange:AFILe:SEParator:COLumn
on page 641
[:SOURce<hw>]:PULM:TRAin:DEXChange:AFILe:EXTension on page 590
[:SOURce<hw>]:PULM:TRAin:DEXChange:AFILe:SEParator:DECimal
on page 591
[:SOURce<hw>]:PULM:TRAin:DEXChange:AFILe:SEParator:COLumn
on page 591
Select (ASCII) Source/Select (ASCII) Destination
In "Mode > Import", access the file select dialog that provides standard file handling
functions.
Where:
●
"Select ASCII Source": defines the file to be loaded (imported)
●
"Select ASCII Destination": selects the filename under that the loaded file is saved
List mode settings