R&S SMA100B - Page 235

Improving level performance
R&S
®
SMA100B
235User Manual 1178.3834.02 ─ 09
Access:
► Select "Clk Syn/Power Sens" > "NRP Sensor Mapping".
The dialog lists all detected R&S NRP sensors for selection and mapping. You can
also browse the network for sensors.
The detected sensors are characterized by the used protocol and the correspond-
ing connector icon. In the "Mapping" column, you can assign the sensor to one of
the available sensor channels. The list can contain several entries but the
R&S SMA100B can only use up to four sensors simultaneously.
The remote commands required to define these settings are described in Chap-
ter 14.15, "SENSe, READ, INITiate and SLISt subsystems", on page 546.
Settings
Sensor Mapping List................................................................................................... 235
Scan............................................................................................................................236
Clear............................................................................................................................236
Add Sensor/Hide 'Add Sensor'....................................................................................236
Add Sensor settings....................................................................................................236
└ Add LAN Sensor settings..............................................................................236
└ Add USB Sensor settings............................................................................. 236
Sensor Mapping List
Shows the sensors that are connected to the R&S SMA100B.
The table informs on the sensor type, specific features and the installed sensor firm-
ware. It also shows the interface the sensor is connected to, including the communica-
tion protocol and the assigned channel.
Using power sensors