R&S SMA100B - Page 550

Remote control commands
R&S
®
SMA100B
550User Manual 1178.3834.02 ─ 09
Setting parameters:
<IP> string
*RST: 0
Example: See Example "Detecting and assigning a power sensor"
on page 547.
Usage: Setting only
Manual operation: See "Add LAN Sensor settings" on page 236
:SLISt:SCAN:USENsor
<DeviceID>, <Serial>
Scans for R&S NRP power sensors connected over a USB interface.
Parameters:
<Serial> integer
Range: 0 to 999999
Setting parameters:
<DeviceID> String or Integer
Range: 0 to 999999
*RST: 0
Example: See Example "Detecting and assigning a power sensor"
on page 547.
Usage: Setting only
Manual operation: See "Add USB Sensor settings" on page 236
:SLISt:CLEar:LAN
Removes all R&S NRP power sensors connected in the LAN from the list.
Example:
See Example "Detecting and assigning a power sensor"
on page 547.
Usage: Event
Manual operation: See "Clear" on page 236
:SLISt:CLEar:USB
Removes all R&S NRP power sensors connected over USB from the list.
Example:
See Example "Detecting and assigning a power sensor"
on page 547.
Usage: Event
Manual operation: See "Clear" on page 236
SENSe, READ, INITiate and SLISt subsystems