R&S SMA100B - Page 549

Remote control commands
R&S
®
SMA100B
549User Manual 1178.3834.02 ─ 09
:SENSe<ch>[:POWer]:FILTer:LENGth[:USER].................................................................. 555
:SENSe<ch>[:POWer]:FILTer:NSRatio............................................................................. 556
:SENSe<ch>[:POWer]:FILTer:NSRatio:MTIMe.................................................................. 556
:SENSe<ch>[:POWer]:FILTer:SONCe.............................................................................. 556
:SENSe<ch>[:POWer]:FILTer:TYPE................................................................................. 557
:SENSe<ch>[:POWer]:FREQuency..................................................................................557
:SENSe<ch>[:POWer]:LOGGing:STATe............................................................................558
:SENSe<ch>[:POWer]:OFFSet........................................................................................558
:SENSe<ch>[:POWer]:OFFSet:STATe..............................................................................558
:SENSe<ch>[:POWer]:SNUMber?................................................................................... 558
:SENSe<ch>[:POWer]:SOURce.......................................................................................559
:SENSe<ch>[:POWer]:STATus[:DEVice]?.........................................................................559
:SENSe<ch>[:POWer]:SVERsion?...................................................................................559
:SENSe<ch>[:POWer]:TYPE?.........................................................................................560
:SENSe<ch>[:POWer]:ZERO.......................................................................................... 560
:SLISt[:LIST]?
Returns a list of all detected sensors in a comma-separated string.
Return values:
<SensorList> String of comma-separated entries
Each entry contains information on the sensor type, serial num-
ber and interface.
The order of the entries does not correspond to the order the
sensors are displayed in the "NRP Sensor Mapping" dialog.
Example: See Example "Detecting and assigning a power sensor"
on page 547.
Usage: Query only
Manual operation: See "Sensor Mapping List" on page 235
:SLISt:SCAN[:STATe] <State>
Starts the search for R&S NRP power sensors, connected in the LAN or via the
USBTMC protocol.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Detecting and assigning a power sensor"
on page 547.
Manual operation: See "Scan" on page 236
:SLISt:SCAN:LSENsor <IP>
Scans for R&S NRP power sensors connected in the LAN.
SENSe, READ, INITiate and SLISt subsystems