R&S SMA100B - Page 583

Remote control commands
R&S
®
SMA100B
583User Manual 1178.3834.02 ─ 09
[:SOURce<hw>]:PULM:MODE <Mode>
Selects the mode for the pulse modulation.
Parameters:
<Mode> SINGle | DOUBle | PTRain
SINGle
Generates a single pulse.
DOUBle
Generates two pulses within one pulse period.
PTRain
Generates a user-defined pulse train.
Specify the pulse sequence with the commands:
[:SOURce<hw>]:PULM:TRAin:ONTime
[:SOURce<hw>]:PULM:TRAin:OFFTime
[:SOURce<hw>]:PULM:TRAin:REPetition
*RST:
SINGle
Example: See Example "Perform pulse modulation" on page 581.
Options: PTRain requires R&S SMAB-K27
Manual operation: See "Pulse Mode" on page 100
[:SOURce<hw>]:PULM:TRIGger:MODE <Mode>
Selects a trigger mode - auto, single, external, external single or external gated - for
generating the modulation signal.
Parameters:
<Mode> AUTO | EXTernal | EGATe | SINGle | ESINgle
*RST: AUTO
Example: See Example "Perform pulse modulation" on page 581.
Manual operation: See "Trigger Mode" on page 101
[:SOURce]:PULM[:INTernal][:TRAin]:TRIGger:IMMediate
If [:SOURce<hw>]:PULM:TRIGger:MODESINGle, triggers the pulse generator.
Example:
See Example "Perform pulse modulation" on page 581.
Manual operation: See "Execute Single Trigger" on page 104
[:SOURce<hw>]:PULM:PERiod <Period>
Sets the period of the generated pulse, that means the repetition frequency of the inter-
nally generated modulation signal.
SOURce subsystem