R&S SMA100B - Page 72

RF signal configuration
R&S
®
SMA100B
72User Manual 1178.3834.02 ─ 09
The "Frequency" tile indicates the reference frequency, current frequency offset
and multiplier values, and phase offset value.
In the "RF Frequency" dialog, you can configure:
● RF frequency, incl. an offset or multiplication factor of a downstream instrument
● The step size for varying the frequency with the rotary knob.
The remote commands required to define the settings are described in Chap-
ter 14.16.4, "SOURce:FREQuency subsystem", on page 642.
Settings
Frequency..................................................................................................................... 72
Main PLL Bandwidth..................................................................................................... 73
Offset.............................................................................................................................73
Multiplier........................................................................................................................73
User Variation................................................................................................................73
└ Variation Active............................................................................................... 73
└ Variation Step..................................................................................................73
Frequency
Sets the RF frequency.
This frequency is output at the RF connector. It does not consider an Offset or multipli-
cation factor (Multiplier).
See "RF frequency and level display with a downstream instrument" on page 66.
Note: Suppressed values in the status bar
For security concerns or certain operating modes, you can hide the frequency and
level display in the status bar.
●
The display has been disabled for security reasons.
See:
– Annotation Frequency
– Annotation Amplitude
●
The display is disabled when list mode is running, see Chapter 7, "List and sweep
mode", on page 171.
Remote command:
[:SOURce<hw>]:FREQuency[:CW|FIXed] on page 644
RF frequency settings