Santana PS-10 User Manual

4B-4 REAR DRIVE SHAFT
Installation
1) Clean carefully the surfaces where driving flanges to hub
and differential group to axle housing meet. Wipe away the
sealant residues which could have stay adhered.
2) Reverse removal procedures noting the following steps:
• Apply recommended sealant to the surfaces where driving
flanges to hub and differential group to shaft housing meet.
• Install new blocking washer and new self braking nuts.
• Apply the specified tightening torques indicated in the
complementary task.
Tightening torques:
• Nuts fixing differential group: 3.5 ÷ 4.25 Kg-m
(35 ÷ 42.5 Nm)
• Screws fixing dragging flange: 3.5 ÷ 4.25 Kg-m
(35 ÷ 42.5 Nm)

Santana PS-10 Specifications

General

Brand	Santana
Model	PS-10
Category	Automobile
Language	English