Santana PS-10 User Manual

4B-6 REAR DRIVE SHAFT
Installation
1) If you were forced to remove the hub and flange assembly,
install it as same as 4B-8.
2) Continue the installation reversing removal procedures, noting
the followings steps:
• Clean and wipe out residues from the contact surfaces
between driving flange and hub and apply a layer of
recommended sealant.
• Install new blocking washers and new O rings to the hub
cap.
• Apply specified tightening torques and those indicated in
the complementary tasks.
Tightening torque for screws fixing dragging flanges:
3.5 - 4.25 Kg-m (35 ÷ 42.5 Nm)

Santana PS-10 Specifications

General

Brand	Santana
Model	PS-10
Category	Automobile
Language	English