4C-4 FRONT AND REAR PROPELLER SHAFTS
5) Replacement shaft showing knockings, bendings, fractures,
rustiness, etc.
6) If radial play is observed in the constant velocity joint then
change the whole propeller shaft.
Removal and repair
7) Before disconnecting axle from its connection to grooved
shaft, check the alignment mark you did. If necessary, make
new alignment marks for installation, to keep the original
balancing.
8) Unscrew the basket (1) and take away grooved shaft (2)
from grooving axle.
9) Dismantle circlip (4) fixing crosshead bearings.
4
1
2
4