Santana PS-10 User Manual

CLUTCH 7C-5
CLUTCH CIRCUIT DRAIN
NOTE:
During the operation, fill the tank with liquid so as to
avoid air entering the system. Only use recommended
hydraulic liquid.
1) Attach a piece of flexible and transparent piping (1) to slave
cylinder bleeder screw (2).
2) Place the free end of the piping in a glass container (3) in
order to collect the clutch fluid. Make sure the end is always
submerged during the bleeding.
3) Loosen the bleeder screw (2).
4) Push the clutch pedal slowly, pausing briefly when the pe-
dal is up.
5) Stop pumping when the liquid comes out without air.
6) Keep the piping end submerged and tighten bleeder screw
(2) at the same time as pushing the pedal down.
7) Adjust clutch fluid level to the tank maximum (Max).
8) Check clutch pedal height and travel (see 7C-4) and adjust
if necessary.
1
3
2

Santana PS-10 Specifications

General

Brand	Santana
Model	PS-10
Category	Automobile
Language	English