13 Detector
13.3 Thermal conductivity detector (TCD)
164
GC-2010 Plus
Linear ... Select linear when connecting the GC to any Chromatopac other than the C-
R8A/C-R7A/C-R7A plus.
When connecting the GC to a C-R7A/CR-7A plus and setting the “ANALOG
SIGNAL TYPE” to “Linear”, the optional signal cable (linear, P/N 221-47251-
92) is required. In the case of “Linear”, the Chromatopac does not need the
wide range calibration.
13.3.2.3 PF menu
PF menu Description
Reference
section
Det Gas
Sets the makeup gas flow rate supplied from the reference cell to the
sample cell.
13.3.3
Next Det
Toggles to the setup screeen of another detector.
The [DET] key can also be used to switch screens.
――
To Next Page
Loading...
