16 Special Functions
16.6 GC Configuration
247
GC-2010 Plus
16.6.7.3 Selecting the detector signals
Select the signal type from the main screen, and then press “DET SIG” to display the
screen shown in Fig. 16.6.7.
Select the type of signal to output. For a description of the settings, refer to “13.5 Setting
the Output Signals” in “13. Detector”.
16.6.7.4 Selecting the temperature signal
Select the signal type from the main screen, and then press “TEMP” to display the
screen shown in Fig. 16.6.8.
Select the temperature signal to be output.
Fig. 16.6.7 Detector signal setup screen
Fig. 16.6.8 Temperature control signal setup screen
For detector signal subtraction,
also specify the channels (1-4)
for the subtraction.
For background signal com-
pensation, also specify the
background signal No.(1 or 2).
The currently set channel
No. is displayed.
The currently set channel No.
is displayed.
When saving the background
signal, specify which signal (1
or 2) should be saved.
To Next Page
Loading...
