Shimadzu GC-2010 Plus - Page 271

16 Special Functions
16.6 GC Configuration
251
GC-2010 Plus
16.6.8.3 Heater Name Customization
Select “6. GC CONFIGURATION” from, the [FUNC] key screen, and then “6. PORT
NAME CUSTOMIZATION”, and finally, select “1. HEATER NAME CUSTOMIZ”, to open
the screen shown in Fig. 16.6.15.
16.6.8.4 Carrier Name Customization
Select “6. GC CONFIGURATION” from the [FUNC] key screen, and then “6. PORT
NAME CUSTOMIZATION”, and finally select “CARRIER NAME CUSTOMIZ”, to open
the screen shown in Fig. 16.6.16.
Fig. 16.6.15 Heater port name setup screen
Fig. 16.6.16 Carrier name setup screen
Only listed heated zone names
can be changed.
To change the names, refer to
“5.3.5 Changing item names”
in “5.3 Basic Key Operations”.
To change the names, refer to
“5.3.5 Changing item names”
in “5.3 Basic Key Operations”.