Siemens CU240S DP-F Parameter Manual

Index
C-414
© Siemens AG 2007 All Rights Reserved
SINAMICS G120 Control Units CU240S, Edition 05/2007
7000
Overview of Speed Control without En-
coder (SLVC), 2-365
7010
Overview of Speed Control with Encoder
(VC), 2-366
7200
Overview of Torque Control without En-
coder (SLVC), 2-367
7210
Overview of Torque Control with Encoder
(VC), 2-368
7500
Speed Controller without Encoder
(SLVC), 2-369
7510
Speed Controller with Encoder (VC),
2-370
7700
Torque Controller and Torque Limitation
without Encoder (SLVC), 2-371
7710
Torque Controller and Torque Limitation
with Encoder (VC), 2-372
7800
Flux Setpoint (SLVC and VC), 2-373
7900
Current Controller & Observer Model with
Encoder (VC), 2-375
Current Controller & Observer Model with-
out Encoder (SLVC), 2-374
8000
Analog outputs and display values, 2-376
A
Active (Parameters), 1-10
Adjustable parameter, 1-8
Alarm
Alarm messages, 3-378
List of Alarm messages, 3-379
ASCII-Table, A-405
B
Bit field (Parameters), 1-12
C
Can be changed (Parameters), 1-11
Contents
ASCII-Table, A-405
Contents overview, Inhalt-5
List of Abbreviations, B-407
D
Data set (Parameters), 1-10
Data type (Parameters), 1-10
Dependency (Parameters), 1-12
Description (Parameters), 1-11
F
Fault messages
List of all Fault messages, 3-379
Function diagrams External Interfaces
Analog Inputs (AI), 2-326
Analog Output (AO), 2-327
Basic Operator Panel (BOP), 2-328
Digital Inputs (DI), 2-324
Fieldbus, Receiving, 2-333
Fieldbus, Transmitting, 2-334
USS on RS232, Receiving, 2-329
USS on RS232, Transmitting, 2-330
USS on RS485, Receiving, 2-331
USS on RS485, Transmitting, 2-332
Function diagrams Free Blocks
Adderd, Subtrscters, Multipliers, Dividers,
Comparators, 2-354
AND-, OR-, XOR- and NOT- Elements,
2-351
FlipFlops, 2-352
Timers, 2-353
Function diagrams General
Symbols in funktion diagrams, 2-319
Function diagrams Internal Setpoint Source
Fixed Frequency (FF) Binary Selection
(P1016 = 2), 2-338
Fixed Frequency (FF) Direct Selection
(P1016 = 1), 2-337
Fixed PID setpoint, Binary Selection
(P2216 = 2), 2-340
Fixed PID setpoint, Direct Selection
(P2216 = 1), 2-339
Motor Potentiometer (MOP), 2-336
PID Motor Potentiometer (PID-MOP),
2-341
Function diagrams Overview
Connection of External and Internal Set-
points, 2-322
General Overview, 2-321
Function diagrams Setpoint Channel
Additional Frequency Modifications, 2-359
PID Controller, 2-357
Ramp Function Generator, 2-360
Setpoint channel and Motor control, 2-356
Wobble Generator, 2-358

Siemens CU240S DP-F Specifications

General

Brand	Siemens
Model	CU240S DP-F
Category	Control Unit
Language	English