CONVEYOR ENHANCEMENTS
Software Configuration
6-98 Aquastorm™ Series Options Guide Rev. 1
6
Configuration
Procedure
Configure the CheckMate™ as follows:
1. Press the menu key on the LCD interface keypad to access configuration
screen #1.
2. Press the enter key to toggle to YES and indicate the CheckMate™ is installed.
3. Press the enter key to accept the configuration.
4. Press the Menu key to accept the changes.
5. Result: The update screen displays and the system returns to the main menu.
6. Press the down arrow key to highlight Conveyor.
7. Press the arrow keys to access the Conveyor Set Point column.
8. Set the conveyor speed to 0.91 M/min. (3 F/min.).
9. Proceed with the Dart MicroDrive configuration. See Hardware Configuration
on page 99.
To Next Page
Loading...