BLOWER ENHANCEMENTS
Repair
16-320 Aquastorm™ Series Options Guide Rev. 1
16
Repair
Introduction The operator responds to the blower fail detect alarm as described in the
Aquastorm 100™ or Aquastorm 200™ Programming and Operations Guide. The
machine maintenance staff checks the blower motor, the blower motor belt, and
blower section airknives to locate the source of the blower fail detect alarm. As
soon as the alarm source is located the maintenance staff repairs the problem,
resets the alarm, and returns the machine to operation.
Contact Electrovert Customer Service to replace a blower motor. For a clogged
airknife See Repair on page 309. For a damaged or broken blower motor belt,
refer to the following information.
In this section Refer to the following to access and replace a blower motor belt:
Topic See Page
Access Blower Motor Belt 16 – 321
Remove/Replace the Blower Belt 16 – 323
Resume System Operation 16 – 326
To Next Page
Loading...