. . . . .
BLOWER ENHANCEMENTS
Repair
2-9317-600-00-0 Aquastorm™ Series Options Guide 16-309
Repair
Introduction Electrosonic™ airknife gaps are factory set and normally do not require
adjustment. The air slot allows for optimal air delivery depending on blower
configuration. All Electrosonic™ airknives are adjusted according to voltage, Hz,
and blower size. The following information is provided in the unlikely event the
gap requires adjustment or an airknive becomes clogged.
Safety To ensure personal safety and avoid equipment damage observe the following:
CAUTION
Qualified maintenance staff should perform the following repair steps. If any
damage to the assembly, or airknife is detected, contact Electrovert Customer
Service.
Tools The following tools are required to complete Electrosonic™ airknife cleaning and
gap adjustments:
• Flat head screwdriver
• T25 torque head screwdriver
• Feeler gauge set
• 5 mm Allen wrench
• 3 mm Allen wrench
To Next Page
Loading...